Honda Accord 2012 Fuse Replacement
Having an electrical issue? It could be a blown fuse — an easy fix you can do yourself.
Follow the steps below to find and replace the fuse:
Step 1: Find the Fuse Box
In your Honda Accord 2012, the interior fuse box is typically located under the dashboard on the driver's side. Some vehicles also have an additional fuse box in the engine compartment. Check your owner's manual or the fuse box cover for the exact location.
Step 2: Identify the Corresponding Fuse
Below is the complete fuse list for your vehicle. Find the circuit that isn't working and note the fuse number and amperage.
Passenger compartment Fuse Box
| Fuse # | Function | Amperage |
|---|---|---|
| 1 | Not Used | |
| 2 | Seat Memory (If equipped) | 7.5 |
| 3 | Washer | 15 |
| 4 | Wiper | 7.5 |
| 5 | Meter | 7.5 |
| 6 | ABS/VSA | 7.5 |
| 7 | ACG | 15 |
| 8 | STS (If equipped) | 7.5 |
| 9 | Fuel Pump | 20 |
| 10 | VB SOL (If equipped) | 10 |
| 11 | SRS | 10 |
| 12 | ODS (Occupant Detection System) | 7.5 |
| 13 | Not Used | |
| 14 | ACM (If equipped) | 10 |
| 15 | Daytime Running Lights | 7.5 |
| 16 | A/C | 7.5 |
| 17 | Accessory, Key, Lock | 7.5 |
| 18 | Accessory | 7.5 |
| 19 | Driver’s Power Seat Sliding (If equipped) | 20 |
| 20 | Moonroof (If equipped) | 20 |
| 21 | Driver’s Power Seat Reclining (If equipped) | 20 |
| 22 | Rear Left Power Window | 20 |
| 23 | Front Accessory Power Socket | 15 |
| 24 | Driver’s Power Window | 20 |
| 25 | Driver’s Side Door Lock | 10 |
| 26 | Left Front Fog Light (If equipped) | 10 |
| 27 | Left Side Small Lights (Exterior) | 10 |
| 28 | Left Headlight High Beam | 10 |
| 29 | TPMS | 7.5 |
| 30 | Left Headlight Low Beam | 10 |
| 31 | Not Used |
Passenger compartment Fuse Box
| Fuse # | Function | Amperage |
|---|---|---|
| 1 | Right Headlight High Beam | 10 |
| 2 | Right Side Small Lights (Exterior) | 10 |
| 3 | Right Front Fog Light (If equipped) | 10 |
| 4 | Right Headlight Low Beam | 10 |
| 5 | Not Used | |
| 6 | Interior Lights | 7.5 |
| 7 | Not Used | |
| 8 | Front Passenger’s Power Seat Reclining (If equipped) | 20 |
| 9 | Front Passenger’s Power Seat Sliding(If equipped) | 20 |
| 10 | Right Side Door Lock | 10 |
| 11 | Rear Right Power Window | 20 |
| 12 | Rear Accessory Power Socket | 15 |
| 13 | Front Passenger’s Power Window | 20 |
| 14 | Not Used | |
| 15 | Premium AMP(If equipped) | 20 |
| 16 | Not Used | |
| 17 | Not Used | |
| 18 | Lumbar Support (If equipped) | 10 |
| 19 | Seat Heater(If equipped) | 15 |
| 20 | Not Used | |
| 21 | Not Used | |
| 22 | Not Used |
Engine compartment Fuse Box
| Fuse # | Function | Amperage |
|---|---|---|
| 1-1 | Battery (4-cylinder models) | 100 |
| 1-1 | Battery (V6 models) | 120 |
| 1-2 | Passenger’s Side Fuse Box | 40 |
| 2-1 | Not Used | |
| 2-2 | ABS/VSA | 40 |
| 2-3 | ABS/VSA Motor | 30 |
| 2-4 | Passenger’s Side Fuse Box | |
| 2-5 | Not Used | |
| 2-6 | Not Used | |
| 3-1 | Not Used (4-cylinder models) | |
| 3-1 | Sub Fan Motor (V6 models) | 30 |
| 3-2 | Wiper Motor | 30 |
| 3-3 | Main Fan Motor | 30 |
| 3-4 | Driver’s Side Light Main | 30 |
| 3-5 | Driver’s Side Fuse Box | |
| 3-6 | Passenger’s Side Light Main | 30 |
| 3-7 | Driver’s Side Fuse Box | |
| 3-8 | IG Main | 50 |
| 4 | Rear Defroster | 40 |
| 5 | Sub Fan Motor (4-cylinder models) | 20 |
| 5 | Not Used (V6 models) | |
| 6 | Not Used | |
| 7 | Not Used | |
| 8 | Heater Motor | 40 |
| 9 | Hazard | 15 |
| 10 | Horn, Stop | 20 |
| 11 | Not Used | |
| 12 | Not Used | |
| 13 | IG Coil | 15 |
| 14 | FI Sub | 15 |
| 15 | Back Up | 10 |
| 16 | Interior Lights | 7.5 |
| 17 | FI Main | 15 |
| 18 | DBW | 15 |
| 19 | Not Used (4-cylinder models) | |
| 19 | Back Up, FI ECU (V6 models) | 7.5 |
| 20 | MG Clutch | 7.5 |
| 21 | Fan Relay | 7.5 |
Step 3: Check the Fuse
Use the plastic fuse puller, typically found in the fuse box, to remove the fuse. Hold it up to a light source. If the metal filament inside is broken or charred, the fuse is bad and needs to be replaced.
Step 4: How to Get a Replacement
You can buy a replacement fuse at any auto parts store. Make sure you match the **amperage (A)** and **physical size** of the fuse exactly. For example, if you need a 20A fuse, get a 20A fuse.
Step 5: Replace the Fuse
Gently press the new fuse into the empty slot. You should feel a slight click when it's securely in place. Test the affected circuit to confirm it's working again.
What Now?
Fuse Was Blown — What to Buy
Ask at any auto parts store (AutoZone, O'Reilly, Advance Auto) for a blade fuse with the same amperage printed on the old one (e.g., 10A, 15A, 20A). Also match the physical size — mini (most modern cars), standard, or maxi. Replacement fuses cost under $5 and most stores sell assorted packs.
Fuse Looks Fine — Other Causes
If the fuse is intact, the problem isn't a blown fuse. Common alternatives include a bad relay (a click-sized electrical switch), a faulty wiring connection, or a failed component (motor, switch, module). At this point, a mechanic's diagnostic is the most reliable next step.
Frequently Asked Questions
What happens if I put in the wrong amperage fuse?
Higher amperage fuses won't protect the circuit and can cause wiring damage or fire. Lower amperage fuses will blow again immediately. Always match the exact amperage.
Why does my fuse keep blowing?
A repeatedly blown fuse indicates an underlying short circuit or overload. Replacing it again won't fix the root cause — consult a mechanic.
Do I need any tools?
Most cars come with a plastic fuse puller in the fuse box lid. If not, fine-tip needle-nose pliers work. A small flashlight helps.
How do I know what size fuse to buy?
Match the amperage printed on the old fuse (e.g., 10A, 15A, 20A) and the physical blade size (mini, standard, maxi). Auto parts stores carry assorted packs.